Right Hand Motion Control Installation - Toro GrandStand 74504TE Service Manual

CONTROLS
Right Hand Motion Control
Installation
1. Install the grip on the right hand motion control
assembly.
2. Secure the cam in place with nut on the motion
control assembly.
NOTE: The flat side should point towards the
ground.
3. Install igus bearing onto the end of the motion
control.
4. Lift the right hand motion control assembly through
the tower. Secure with bolt and nut in the front
and 2 bolts on top of the tower. Ensure pivot tab is
installed. Torque to 75 +/- in. lbs. Refer to page 4-3.
4
5. Install bolt through the motion control assembly,
washer, and upper control rod end. Secure with nut.
Torque to 36 +/- 4 ft. lbs.
6. Place bolt through the IHT control arm. Lower end
of the control rod and secure with nut. Torque to 36
+/- 4 ft. lbs.
NOTE: Forward position of slot for 10 mph, rear
position of slot for 8 mph.
NOTE: Ensure control rod does not rub on the fuel
tank tube mount.
7. Once both sides are complete, see "Speed Setting
Procedure," page 6-2.
4-4 TORO®- Grandstand Service Instruction Manual