Adjusting Motion Control Levers; Left Hand Motion Control Removal - Toro GrandStand 74504TE Service Manual

CONTROLS
Adjusting Motion-Control Levers
(Figure 18)
NOTE: If the motion-control levers do not align
horizontally, adjust the right side motion-
control lever.
1. Disengage the PTO, move the motion-control levers
to the neutral position. Set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Push the motion-control levers out of the NEUTRAL-
LOCK position.
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever.
4
NOTE: To adjust the motion-control levers
horizontally, adjust the cam.
5. Release the cushion from the rear of the machine.
6. Loosen the nut holding the cam.
7. Adjust the cam until it aligns with the left motion-
control lever and tighten the nut.
NOTE: Moving the cam clockwise (in the vertical
position) lowers the handle; moving the
cam counterclockwise (in the vertical
position) raises the handle.
Important: Ensure that the flat portion of the cam
does not go above a vertical position (right
or left); otherwise you may damage the
switch.
8. Repeat steps 3 through 8 for the left motion-control
4-2

Left Hand Motion Control Removal

NOTE: IHT are shipped with the Internalized
Hydraulic Transmission (Figure 19).
Figure 19
1. Lower the cushion.
2. Remove the fuel tank, see "Fuel Tank Removal,"
page 3-10.
3. Remove bolt and nut from the slot on the left IHT
arm.
4. Remove bolt and nut from the top of the control
holding pivot tab and left hand control assembly.
5. Remove the control rod from the tower.
6. Unclip the left hand motion control switch.
7. Remove the bolt and nut from the front of tower.
8. Remove the 2 bolts and nuts securing the left hand
motion control to the tower.
9. Place the left hand motion control through the tower.
TORO®- Grandstand Service Instruction Manual
(Hydro Arm)