Mower Deck; Deck Leveling - Toro GrandStand 74504TE Service Manual

Deck Leveling

NOTE: It is suggested to level the deck side to side
and front to back at the same time.
Leveling the mower deck from side to side.
1. Loosen the side nut and jam nut in the yokes.
2. Position the blades perpendicular to the machine.
Measure the blade tips on a level surface.
3. Rotate the top bolt of the yokes to adjust the height
of the mower deck.
NOTE: Rotate the bolts clockwise to raise the
deck, rotate the bolt counterclockwise to
lower it.
4. Tighten the jam nuts and side bolts.
5. Verify the deck is level side to side by measuring at
the blade tips (Figure 35).
Figure 35
TORO®- Grandstand Service Instruction Manual

MOWER DECK

Leveling the mover deck front to back
1. Adjust the tire pressure in the rear tires to the
correct specifications.
NOTE: Tire pressure should be 13 psi.
2. Position 1 blade front-to-rear. Measure the front
and rear locations of the blade on a level surface.
Measure each end of the blade tip.
NOTE: The mower blade should be 6 mm (1/4 in.)
lower in the front, than in the rear of the
blade tip.
3. Loosen the jam nut and side bolt in the yokes.
4. Rotate the top bolt of the yokes to adjust the height
of the mower deck.
NOTE: Rotate the bolts clockwise to raise the
deck, rotate the bolt counterclockwise to
lower.
5. Tighten the jam nuts and side bolts.
6. Verify deck is level from front to rear by measuring
at the blade tips (Figure 36).
Figure 36
7
7-1