Safety - Toro GrandStand 74504TE Service Manual

General Information
This symbol means WARNING or PERSONAL
SAFETY INSTRUCTION - read the
!
instruction because if has to do with
your safety. Failure to comply with
the instruction may result in personal
injury or even death.
This manual is intended as a service and repair
manual only. The safety instructions provided here-
in are for troubleshooting, service, and repair of the
Think Safety First
Avoid unexpected starting of engine...
Always turn off the engine and disconnect the spark
plug wire(s) before cleaning, adjusting, or repair.
Avoid lacerations and amputations...
Stay clear of all moving parts whenever the engine
is running. Treat all normally moving parts as if
they were moving whenever the engine is running
or has the potential to start.
Avoid burns...
Do not touch the engine, muffler, or other compo-
nents which may increase in temperature during
operation, while the unit is running or shortly after
it has been running.
Avoid fires and explosions...
Avoid spilling fuel and never smoke while work-
ing with any type of fuel or lubricant. Wipe up any
spilled fuel or oil immediately. Never remove the
fuel cap or add fuel when the engine is running.
Always use approved, labeled containers for storing
or transporting fuel and lubricants.
Avoid asphyxiation...
Never operate an engine in a confined area without
proper ventilation.
TORO®- Grandstand Service Instruction Manual
SAFETY INFORMATION
Toro GrandStand Stand-on Mower. The GrandStand
mower and attachment operator's manuals contain
safety information and operating tips for safe op-
erating practices. Operator's manuals are available
through your Toro parts source or:
The Toro Company
Publications Department
8111 Lyndale Avenue South
Bloomington, MN 55420
Avoid injury from batteries...
Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes, and clothing. Battery
gases can explode. Keep cigarettes, sparks, and
flames away from the battery.
Avoid injury due to inferior parts...
Use only original equipment parts to ensure that
important safety criteria are met.
Avoid injury to bystanders...
Always clear the area of bystanders before starting
or testing powered equipment.
Avoid injury due to projectiles...
Always clear the area of sticks, rocks, or any other
debris that could be picked up and thrown by the
powered equipment.
Avoid modifications...
Never alter or modify any part unless it is a factory
approved procedure.
Avoid unsafe operation...
Always test the safety interlock system after making
adjustments or repairs on the machine. Refer to the
Electrical section in this manual for more informa-
tion.
1
1-1