Misfeed In The Machine - Sharp MX-M232D Operation Manual

MISFEED IN THE MACHINE

1
Open the bypass tray and the side
cover.
If the misfed paper is visible
here, go to "C. Misfeed in the
transport area" (p.96).
If paper is misfed here, go to
"A. Misfeed in the paper feed
area" (p.94).
A. Misfeed in the paper feed area
1
Push gently on both ends of the front
cover and open it.
2
Carefully remove the misfed paper.
Turn the roller rotating knob in the
direction of the arrow to assist in
removing it.
Roller rotating knob
The fusing unit is hot. Do not touch
Warning
the fusing unit when removing misfed
paper. Doing so may cause a burn or
injury.
Do not touch the photoconductive drum
Caution
(green portion) when removing the misfed
paper. Doing so may damage the drum and
cause smudges on copies.
Be careful not to tear the
misfed paper during
removal.
2
Check the misfeed location. Remove
the misfed paper following the
instructions for each location in the
illustration below.
If paper is misfed here, go to
"B. Misfeed in the fusing area" (p.95).
3
Close the front cover and side cover.
• When closing the front cover, gently hold
Note
both ends.
• When closing the side cover, press on the
handle.
• If the message does not clear, check again
to make sure that no pieces of paper
remain.
TROUBLESHOOTING
The message " Clear
paper path." will be
cleared and copying will
be possible.
94
6