The Original Size Is Not Automatically Selected Or The Copy Is Not Made On Paper That Matches The Size Of The Original; Copies Are Smudged Or Dirty; White Or Black Lines Appear On Copies; Paper Size For A Paper Tray Cannot Be Set - Sharp MX-M232D Operation Manual

TROUBLESHOOTING
Problem
The original size is not
automatically selected or the copy
is not made on paper that matches
the size of the original.

Copies are smudged or dirty.

White or black lines appear on
copies.
Paper size for a paper tray cannot
be set.
A copy job stops before it is
finished.
85
Cause and solution
Was the SPF/RSPF (or document cover) opened
completely when the original was placed on the document
glass?
→ Open the SPF/RSPF completely and then place the original on the
document glass. Close the SPF/RSPF (or document cover).
The original is curled or folded.
→ The original size cannot be correctly detected if the original is
curled or folded. Straighten the original.
The original has many solid black areas.
→ If the original includes solid black areas, the original size may not
be detected automatically. Press the [SPECIAL FUNCTION] key
and select "ORIG. SIZE ENTER" to specify the original size.
The machine is directly exposed to sunlight.
→ Install in a location that is not exposed to sunlight.
The original is smaller than A5 (5-1/2" x 8-1/2") size.
→ If the original is smaller than A5 (5-1/2" x 8-1/2"), the size cannot
be detected. Follow the procedure in "USING THE BYPASS
TRAY TO COPY A SPECIAL SIZE ORIGINAL" to make the copy.
The original is not a standard size.
→ If the original is a small non-standard size, the size cannot be
detected. Manually select a size close to the original size, or
follow the procedure in "USING THE BYPASS TRAY TO COPY A
SPECIAL SIZE ORIGINAL" to make the copy.
The document glass or the underside of the document
cover/SPF/RSPF is dirty.
→ Clean regularly.
Original smudged or blotchy.
→ Use a clean original.
The scanner glass for the SPF/RSPF is dirty.
→ Clean the long, narrow scanning glass.
The transfer charger is dirty.
→ Clean the transfer charger.
Copying or printing is performed.
→ Set the paper size after copying or printing is complete.
The machine has stopped temporarily due to running out
of paper or a misfeed.
→ Load paper or remove the misfeed, and then set the paper size.
An interrupt copy job is in progress.
→ Set the paper size after the interrupt copy job is finished.
The display or the DATA indicator is blinking.
→ Data is being held in memory. Print the data in memory or clear it
from memory.
The paper output tray is full.
→ Long copy runs are automatically paused every 250 copies.
Remove the copies in the paper output tray and press the
[START] key ( ) to resume copying.
The tray is out of paper.
→ Load paper.
Page
43
–
–
–
36
36
101
–
101
102
–
24, 92
48
49, 51
34
24