Set The Number Of Copies - Sharp MX-M232D Operation Manual

5
Press the [START] key (
copying.
Copying from the SPF/RSPF
1
Make sure that an original has not
been left on the document glass.
Close the SPF/RSPF.
2
Adjust the original guides to the size
of the original(s).
3
Set the original(s) face up in the
document feeder tray.
• If the original is a non-standard size or the
Note
size was not detected correctly, see
"SELECTING THE ORIGINAL SIZE"
(p.35).
• If the auto paper select function has been
disabled in the system settings (p.123),
use the [PAPER SELECT] key to select
the desired paper size.
• To copy onto paper of a different size,
press the [PAPER SELECT] key and
select the desired paper size.
• Paper in a different orientation from the original
may be selected if the auto paper select or
auto image function has been selected. In this
case, the image of the original will be rotated.
• To use the bypass tray, select it manually.
• Do not place originals of different sizes
together in the document feeder tray. This
may cause misfeeds.
) to begin
The copy is delivered to
the paper output tray.
The original size appears
in the display and the
most suitable paper size
is automatically selected.
Insert the stack into the
document feeder tray until
it stops.
• The centre tray can hold a maximum of
Note
250 sheets (150 sheets when the job
separator tray kit is installed).
• About one minute after copying ends,
"Auto clear"
the copy settings to the default settings.
The setting for "Auto clear" can be
changed in the system settings.
• To cancel a copy job in progress, press
the [C] key.
• Differences in copy conditions may cause
the position of the printed copy image to
vary even the copies are of the same
original on the same paper. For more
information, see "Points concerning the
position of the printed copy image" on
(p.32).
Do not place originals of different sizes
Note
together in the document feeder tray. This
may cause misfeeds.
4

Set the number of copies.

5
Press the [START] key (
copying.
MNO
The copies are delivered to the
centre tray.
WXYZ
The default output mode for
@.-_
copying from the SPF/RSPF is
AD-END
sort mode.
The output mode can be
changed using the automatic
sort selection setting in the system settings.
• The centre tray can hold a maximum of
Note
250 sheets (150 sheets when the job
separator tray kit is installed).
• About one minute after copying ends,
"Auto clear"
the copy settings to the initial settings.
The duration of time after which "Auto
clear" clears the copy settings can be
changed in the system settings.
• To stop copying in the middle of a run,
press the [C] key. If you find it difficult to
remove the original from the document
feeder tray, open the feeding roller cover
before removing the original. If you pull
out the original without opening the
feeding roller cover, the original may
become dirty.
COPY FUNCTIONS
(p.22) activates and restores
(p.118)
) to begin
(p.49)
(p.123)
(p.22) activates and restores
(p.118)
30
3