Device Control; Mem. For Printer; Waiting Copy Lamp Setting; Usb2.0 Mode - Sharp MX-M232D Operation Manual

SYSTEM SETTINGS GUIDE

DEVICE CONTROL

These programs are used to configure settings for
hardware functions of the machine. To access one of
these programs, select "DEVICE CONTROL" in the
mode selection screen, select the desired program in
the device control screen, and press the [OK] key.

WAITING COPY LAMP SETTING

This program is used to select whether the copy lamp
(light source) is on or off when the machine is in
standby mode. If the copy lamp (light source) is set to
turn off in standby mode, power will be conserved,
however, the first copy time will be longer than if the
lamp is on.
The factory default setting is "ON".
Select "WAITING COPY LAMP SETTING" and press
the [OK] key. The following screen will appear.
COPY LAMP SETTING
ON
OFF
Select "ON" or "OFF" with the [ ] or [ ]
1
key.
Press the [OK] key.
2
OFFSET FUNCTION
When the offset function is enabled, sets of output will
be offset from each other for easy separation when
copying is performed in sort mode or non-sort mode.
The offset function can be enabled separately for the
top tray (this only appears if the job separator tray kit
has been installed) and centre tray.
The function is initially enabled (factory default setting)
for both the top tray and the centre tray.
Select "OFFSET FUNCTION" and press the [OK] key.
The following screen will appear.
OFFSET FUNCTION
UPPER TRAY
CENTRE TRAY
Select "UPPER TRAY" or "CENTRE TRAY"
1
with the [ ] or [ ] key.
Press the [OK] key.
2
• The setting is enabled and a checkmark
appears in the checkbox.
• If this procedure is performed when the setting
is already enabled, the checkmark is cleared
and the setting is disabled.
* This function is not available in some countries and regions.
117

MEM. FOR PRINTER

(When the dual function board is installed)
The machine is equipped with memory that stores
scanned original image data. Part of this memory is
also used to store print data. This program is used to
set the percentage of memory that is allocated to the
print function. The memory allocation can be set from
30% to 70% in increments of 10%.
The factory default setting is "50%".
Select "MEM. FOR PRINTER" and press the [OK] key.
The following screen will appear.
MEM. FOR PRINTER
30%
40%
50%
60%
Select the desired percentage with the [ ]
1
or [ ] key.
Press the [OK] key.
2
The memory for storing original image data
Note
and print data is 16 MB. An optional memory
module can be installed to expand memory
to 272 MB (the module adds 256 MB).

USB2.0 MODE

This sets the data transfer speed of the USB 2.0 port.
The factory default setting is "HI-SPEED".
If you wish to use USB 2.0 (Hi-Speed mode), be sure
to read "System requirements for USB 2.0 (Hi-Speed
mode)" (p.118) to verify that your system and the
machine settings are configured appropriately.
Select "USB2.0 MODE" and press the [OK] key. The
following screen will appear.
USB2.0 MODE
FULL-SPEED
HI-SPEED
Select the transfer speed with the [ ] or
1
[ ] key.
Press the [OK] key.
2