Sharp MX-M232D Operation Manual page 19

19
20
Document cover (when installed)
13
Open to make a copy from the document glass.
Side cover
14
Open to remove misfed paper.
Side cover handle
15
Pull to open the side cover.
Bypass tray guides
16
Adjust to the width of the paper when using the
bypass tray.
Bypass tray
17
Special paper (heavy paper or transparency film)
can be fed from the bypass tray.
Bypass tray extension
18
Pull out when feeding large paper such as A3 and
B4 (11" x 17" and 8-1/2" x 14").
Toner cartridge lock release lever
19
To replace the toner cartridge, pull out the toner
cartridge while pushing on this lever.
Toner cartridge
20
Contains toner.
Document feeder tray (when the SPF/RSPF is
21
installed)
Place the original(s) that you wish to scan face up
here. Up to 40 sheets can be placed.
Original guides (when the SPF/RSPF is
22
installed)
Adjust to the size of the originals.
Feeding roller cover (when the SPF/RSPF is
23
installed)
Open to remove misfed originals.
21 22 23
26 25
Right side cover (when the SPF/RSPF is
24
installed)
Open to remove misfed originals.
Fusing unit release levers
25
To remove the paper misfed in the fusing unit, push
down on these levers and remove the paper.
Warning
Roller rotating knob
26
Rotate to remove misfed paper.
Exit area (when the SPF/RSPF is installed)
27
Originals exit the machine here after
copying/scanning when the SPF/RSPF is used.
Photoconductive drum
28
Images are formed on the photoconductive drum.
Caution
Fusing unit paper guide
29
Open to remove misfed paper.
Note
BEFORE USING THE MACHINE
27
24
28
The fusing unit is hot. Do not touch
the fusing unit when removing
misfed paper. Doing so may cause a
burn or injury.
Do not touch the photoconductive drum
(green portion) when removing the misfed
paper. Doing so may damage the drum and
cause smudges on copies.
The model name is on the front cover of the
machine.
2
29
18