Copy Functions; Normal Copying - Sharp MX-M232D Operation Manual

Chapter 3
3

COPY FUNCTIONS

This chapter explains how to use the copy functions.

NORMAL COPYING

This section explains how to make a regular copy.
If "Auditing mode" has been enabled (p.114), enter your 5-digit account number.
Copying from the document glass
1
Open the SPF/RSPF and place the
original face down on the document
glass.
An original up to A3 (11" x 17") can be
Note
placed on the document glass.
2
Close the SPF/RSPF.
If the original is a non-standard size or the
Note
size was not detected correctly, see
"SELECTING THE ORIGINAL SIZE" (p.35).
29
Align the upper left-hand corner
of the original with the tip of the
mark.
The original size is
automatically detected.
After placing the original, be
sure to close the SPF/RSPF. If
left open, parts outside of the
original will be copied black,
causing excessive use of toner.
3
Make sure that the desired paper tray
is selected.
Ready to copy.
A4
AUTO
100%
A4
AUTO
To load paper, see "LOADING PAPER" (p.24).
• If the auto paper select function has been
Note
disabled in the system settings (p.123),
use the [PAPER SELECT] key to select
the desired paper size.
• If you wish to use a size of paper different
from the size automatically selected by
the machine, use the [PAPER SELECT]
key to select the desired paper size.
• Paper in a different orientation from the
original can be selected if the auto paper
select or auto image function has been
selected. In this case, the image of the
original will be rotated.
• To make a copy of a small original such as
a card, follow the procedure in "USING
THE BYPASS TRAY TO COPY A
SPECIAL SIZE ORIGINAL" (p.36).
• To use the bypass tray, select it manually.
4
Set the number of copies.
If you are making two or more copies each
Note
of multiple original pages, you can select the
sort function to collate the copies into sets.
(p.49)