Misfeed In The Machine; Side Cover - Sharp MX-M200D Operation Manual

MISFEED IN THE MACHINE

To remove a paper misfeed from the machine, the bypass tray and then the side cover must be opened. Check
whether the misfeed occurred in A, B, or C below and then follow the misfeed removal procedure for that location.
1
Open the bypass tray and then the

side cover.

Location C
If paper is misfed here, go to "Misfeed in C"
(page 33).
Location A
If paper is misfed here, go to "Misfeed in A"
(below).
Misfeed in A
1
Open the front cover.
Push gently on both ends of the
front cover to open it.
2
Turn the roller rotating knob in the
direction of the arrow to remove the
misfed paper.
Be careful not to tear the misfed
Roller rotating
paper during removal.
knob
The fusing unit is hot. Do not touch
Warning
the fusing unit when removing
misfed paper. Doing so may cause a
burn or injury.
Do not touch the photoconductive drum
Caution
(green portion) when removing the misfed
paper. Doing so may damage the drum and
cause smudges on copies.
TROUBLESHOOTING AND MAINTENANCE
2
Determine where the misfeed
occurred.
Location B
If paper is misfed here, go to
"Misfeed in B" (page 32).
3
Close the front cover and the side
cover.
The message "
path." will be cleared and
copying will be possible.
• When closing the front cover, gently hold
Note
both ends.
• When closing the side cover, hold the
handle.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
2
Clear paper
31