Table of Contents
Advertisement
Chapter 4: Router Connections
5. Set the NSM Card-Edge Parameters
82
5. When finished, turn the left scroll knob until the PUSH EXIT parameter
appears.
6. Press the PUSH EXIT display button to return to the main Parameter
Adjustment Control cluster menu.
Note
See the Installation and Operation Manual for your NEO module
for more detailed information about setting parameters.
1. Press the left (Esc) button until the NSM message appears on the VFD
display
2. Press the right (Sel) button.
3. Use the toggle switch (Nav) to scroll through the parameter list until Setup
is highlighted.
4. Press the right (Sel) button.
5. Use the toggle switch (Nav) to scroll through the parameter list until Nav
Mode is highlighted.
6. Press the right (Sel) button.
7. Use the toggle switch (Nav) to scroll through the parameter list until All
List is highlighted.
8. Press the right (Sel) button.
9. Press the left (Esc) button.
10. Press the left (Esc) button again.
11. Use the toggle switch (Nav) to scroll through the parameter list until XY
Level is highlighted.
12. Press the right (Sel) button.
13. Use the toggle switch (Nav) to scroll through the values until 0 (on the first
NSM) or 1 (on the second NSM) is reached.
14. Press the left (Esc) button to set the value.
15. Use the toggle switch (Nav) to scroll through the parameter list until
SrcOffset is highlighted.
16. Press the right (Sel) button.
17. Use the toggle switch (Nav) to scroll through the values until 1 is reached.
18. Press the left (Esc) button to set the value.
19. Use the toggle switch (Nav) to scroll through the parameter list until
DestOffset is highlighted.
20. Press the right (Sel) button.
21. Use the toggle switch (Nav) to scroll through the values until 0 is reached.
22. Press the left (Esc) button to set the value.
IconMaster Installation and Configuration Manual
Advertisement
Table of Contents
