Table of Contents
Advertisement
Figure 4-29. RS-232/422-E Port on the ICONM-BO-V Breakout Module
3. Set the IP Address for the MKE-3901 Module
IconMaster Installation and Configuration Manual
8. On the MKE-3901 back module, connect the Key 1 input source to Key 1
and Fill 1 as appropriate.
9. On the MKE-3901 back module, connect the Key 2 input source to Key 2
and Fill 2 as appropriate.
Note
If you are connecting Ethernet 1 to a network hub/switch, the
IconMaster control panel must be connected to the same
switch.
10. On the MKE-3901 back module, connect the Ethernet 1 connection for
MKE-3901 control to a network hub/switch using a straight-through
Ethernet cable.
11. On the MGI-3903 back module, two Ethernet connection options for
MGI-3903 control and logo download as follows:
•
To the same network/hub as Ethernet 1 using a normal Ethernet cable.
•
To a dedicated switch used for the MGI functionality using a normal
Ethernet cable.
12. Power up the system.
1. Press the left (Esc) button until the message MKE3901 appears on the VFD
display.
2. Press the right (Enter) button.
3. Use the toggle switch (Nav) to scroll through the parameter list until Status
is highlighted.
4. Press the right (Enter) button.
5. Use the toggle switch (Nav) to scroll through the parameter list until Other
is highlighted.
6. Press the right (Enter) button.
7. Use the toggle switch (Nav) to scroll through the parameter list until
IP_Address is highlighted.
8. Press the right (Enter) button.
9. Continue pressing the right (Enter) button until the cursor is under the digit
you want to change.
10. Use the toggle switch (Nav) to change the digit.
Chapter 4: Router Connections
RS-232/422-E Port
119
Advertisement
Table of Contents
