Table of Contents
Advertisement
IconMaster Installation and Configuration Manual
•
If 22 Inputs is selected, the primary source buttons will be split into
one group of inputs numbered 1 – 11, and another group numbered 12 –
22. The far right primary source button will be used as the SHIFT
button. When set to 22 Inputs mode, the SHIFT button toggles
between 1 – 11 and 12 – 22.
Note
It is strongly suggested that you retime the IconMaster system if
you change from 12 to 22 input mode. This will ensure the
additional 10 inputs are correctly timed into IconMaster. See
page 191 for information on setting the timing for an IconMaster
system.
•
Fast Reset Behavior
This setting allows you to quickly reset audio gain and/or PROC parameter
settings for an IconMaster input source, internal or external keyer, Audio
Over, or audio control item on the Audio Control Panel.
There are three separate operations that are enabled when the Fast Reset
function is selected: SET, CLEAR, and RECALL. If the SET function is
enabled, the parameter will not be reset, but its current value will be saved
as the source's user-saved reset value. This is the value that will be used
during a RECALL operation. If the CLEAR function is enabled, the
user-saved reset value will be cleared (back to factory value), and the
keyer's parameters will also be reset back to this factory value. If the
RECALL function is enabled, the user-saved reset value set up through a
SET operation will be applied.
Reset values can be either a factory reset values (0 dB gain, and default
keyer values), or can be user-saved reset values, which are saved on a
source-by-source basis for audio gains and on a keyer-by-keyer basis for
keyer settings.
•
If Audio Gain + Proc is selected, the IconMaster will reset the audio
gains of the selected source or audio configuration item to unity. It also
resets all PROC audio input parameters to their original default values.
•
If Audio Gain is selected, the IconMaster will reset the audio gains of
the selected source or audio configuration item to unity, but it will not
reset any of the PROC audio input parameters.
•
When fast resetting a keyer, all keyer parameters will be reset to their
defaults.
•
When fast resetting an Audio Over, the Audio Over mix ratio will be
reset to 50/50.
•
Take Button
This setting affects the system behavior when the TAKE button is pressed
during a transition.
Chapter 8: Configuring IconMaster
197
Advertisement
Table of Contents
