Table of Contents
Advertisement
6. Set the IP Address for the MGI-3903 Module
IconMaster Installation and Configuration Manual
3. Use the toggle switch (Nav) to scroll through the parameter list until Status
is highlighted.
4. Press the right (Enter) button.
5. Use the toggle switch (Nav) to scroll through the parameter list until Other
is highlighted.
6. Press the right (Enter) button.
7. Use the toggle switch (Nav) to scroll through the parameter list until
IP_Address is highlighted.
8. Press the right (Enter) button.
9. Continue pressing the right (Enter) button until the cursor is under the digit
you want to change.
10. Use the toggle switch (Nav) to change the digit.
11. Press the right (Enter) button to move to the next digit.
12. Repeat the previous three steps until you have changed the IP address.
13. Press the right (Enter) button until the cursor is under the space at the end
of the IP address.
14. Press the left (Esc) button to accept the change.
1. Press the left (Esc) button until the message MGI-3903-R appears on the
VFD display.
2. Press the right (Enter) button.
3. Use the toggle switch (NAV) to scroll through the parameter list until
IP_Address is highlighted.
4. Press the right (Enter) button.
5. Continue pressing the right (Enter) button until the cursor is under the digit
you want to change.
6. Use the toggle switch (Nav) to change the digit.
7. Press the right (Enter) button to move to the next digit.
8. Repeat the previous three steps until you have changed the IP address.
9. Press the right (Enter) button until the cursor is under the space at the end
of the IP address.
10. Press the left (Esc) button to accept the change.
Chapter 4: Router Connections
115
Advertisement
Table of Contents
