Table of Contents
Advertisement
Chapter 4: Router Connections
4. Make Connections on the Panacea and SPT
5. Set the IP Address for the MKE-3901 Module
104
7. On the MKE-3901 back module, connect the Key 1 input source to Key 1
and Fill 1 as appropriate.
8. On the MKE-3901 back module, connect the Key 2 input source to Key 2
and Fill 2 as appropriate.
9. On the MKE-3901 back module, supply Squeeze Bkgd by an external
router.
Note
If you are connecting Ethernet 1 to a switch, the IconMaster
control panel must be connected to the same switch.
10. Connect the two Ethernet ports as follows:
Ethernet 1 (connection for MKE-3901 control) to a switch using a
straight-through Ethernet cable
Ethernet 2 (two connection options for MGI-3903 control and logo
download)
•
To the same switch as Ethernet 1 using a normal Ethernet cable
•
To a dedicated switch used for the MGI functionality using a normal
Ethernet cable
11. Power up the system.
The SPT-LSERIAL is installed in the control line, as shown in the example in
Figure 4-17 on page 103.
•
The maximum allowable distance for each segment of the X-Y coaxial
cable run is 2,000 ft (609 m).
•
The maximum length for each RS-232 segment is 50 ft (15 m).
•
The maximum length for each RS-422 segment is 2,000 ft (609 m).
•
Up to 64 additional serial ports may be added.
Figure 4-15 on page 99 shows the connector pin assignments on both ends of
the connection (the cable wiring description is shown between the connectors).
Table 4-1 on page 100 shows the power requirements for the SPT-LSERIAL
adaptors.
1. Press the left (Esc) button until the message MKE3901 appears on the VFD
display.
2. Press the right (Enter) button.
3. Use the toggle switch (Nav) to scroll through the parameter list until Status
is highlighted.
4. Press the right (Enter) button.
5. Use the toggle switch (Nav) to scroll through the parameter list until Other
is highlighted.
IconMaster Installation and Configuration Manual
Advertisement
Table of Contents
