Table of Contents
Advertisement
2. Make Additional Connections
3. Set the IP Address for the MKE-3901 Module
IconMaster Installation and Configuration Manual
3. On the second NSM back module, connect a maximum of 7 video audio
inputs to the BNC connections labeled In 1 to In 7.
4. Connect Out 1 on the first NSM to AES Bus A on the MKA-3901. This can
be done by direct connection, or by ICONM-BO-VAB or
ICONM-BO-VAC breakout module connection.
5. Connect Out 2 on the first NSM to AES Bus B on the MKA-3901.
6. Connect Out 1 on the second NSM to In 6 on the first NSM.
7. Connect Out 2 on the second NSM to In 7 on the first NSM.
1. Connect your composite station reference to the Ref Inputs and Genlock
connection as shown in Figure 4-6.
2. On the MKE-3901 back module, connect Key 1 input source to Key 1 and
Fill 1 as appropriate.
3. On the MKE-3901 back module, connect Key 2 input source to Key 2 and
Fill 2 as appropriate.
4. On the MKE-3901 back module, Squeeze Bkgd can be supplied by an
external router.
Note
If you are connecting Ethernet 1 to a switch, the IconMaster
Control Panel must be connected to the same switch.
5. Connect the two Ethernet ports as follows:
Ethernet 1 (connection for MKE-3901 control) to a switch using a
straight-through Ethernet cable
Ethernet 2 (two connection options for MGI-3903 control and logo
download)
•
To the same switch as Ethernet 1 using a normal Ethernet cable
•
To a dedicated switch used for the MGI functionality using a normal
Ethernet cable
6. Power up the system.
1. Press the left (Esc) button until the message MKE3901 appears on the VFD
display.
2. Press the right (Enter) button.
3. Use the toggle switch (Nav) to scroll through the parameter list until Status
is highlighted.
4. Press the right (Enter) button.
5. Use the toggle switch (Nav) to scroll through the parameter list until Other
is highlighted.
Chapter 4: Router Connections
85
Advertisement
Table of Contents
