Table of Contents
Advertisement
IconMaster Installation and Configuration Manual
Chapter 9: Enabling a RouterMapper Database for Use with an IconMaster System
7. Select the Device tab. In the text box directly above the Set Default button,
enter the IP address for the IconMaster's MKE-3901 module, and then close
the window. Do not change any other information in this tab! If you do,
you will lose your connection to the IconMaster and you will need to start
the process all over again.
Figure 9-13. Navigation Properties Window
8. Double-click on the IconMaster (MKE) sub-entry under the
Configuration selection. The Configuration for IconMaster (MKE)
window will appear.
Figure 9-14. Configuration for IconMaster (MKE) Window
9. Highlight the device configuration you want to transfer, and then click
Perform Transfer to send the router database to the IconMaster. A
message will appear that asks you to confirm the transfer. Click Yes.
10. After the transfer is complete, click Refresh Device, and then click List
Configuration. The XML files will be listed on the right side under List of
All Configurations on the Device. Confirm that the config.xml and
routerdb.xml files are listed.
At this point, you have built a router database using RouterMapper, and
transferred the database to the IconMaster using Navigator. The next steps will
allow you to assign the router sources as IconMaster's inputs.
229
Advertisement
Table of Contents
