Table of Contents
Advertisement
Chapter 2: Installation
46
Jumpers J1, J4, J2, and J3
Figure 2-30. Jumpers on ICONM-BO-V (for BNC Connectors)
To set the individual jumpers, follow these steps:
1. Move jumpers J1 and J4 to set the A/O 1 (top BNC connector) to either
Unbalanced or Balanced or (see Figure 2-31).
AES A/O 1 unbalanced
J1
J4
J2
Figure 2-31. A/O 1 Jumpers
2. Move Jumpers J2 and J3 to set A/O 2 (bottom BNC connector) to either
Unbalanced or Balanced or (see Figure 2-32).
J3
J1
IconMaster Installation and Configuration Manual
AES A/O 1 balanced
J4
J2
J3
Advertisement
Table of Contents
