Table of Contents
Advertisement
Table 2-8. DB-9 (RS-232 and RS-422) Connector Usage
Connector
Use
RS-232-A
MKE-3901 machine control
RS-232/422-B MKE-3901 automation control 38400
RS-232/422-C Reserved
RS-232-D
MGI-3903 EAS
RS-232/422-E MKE-3901 external router
control
IconMaster Installation and Configuration Manual
Table 2-8 shows default settings for the DB-9 connectors. These connector
assignments can be changed via the ICU Serial Port Configuration Settings
dialog box. For more information, see the IconMaster Functional Operations
and Configuration Manual for system software release 3.0 or higher.
Baud Rate
38400
38400
9600
38400
Common DB-9 Cable Arrangements Examples
IconMaster
1
RxD 2
TxD 3
4
GND 5
6
7
8
9
Figure 2-36. RS-232 IconMaster Port E to Integrator or Panacea Pin
Connections
Note
If re-assigned to port A, use a straight-through connection instead
of this null-modem connection.
Notes
See page 132 for more machine control information
Jumper J18 on the MKE-3901 must be set to the
required standard and jumper pack A1 on the
breakout module must be set to the same standard as
J18 (see page 31 for more jumper information)
See page 135 and page 135 for more automation
control information
Reserved for future use
Connect the EAS receiver for emergency
notification messages
Jumper J17 on the MKE-3901 must be set to the
required standard and jumper pack A2 on the
breakout module must be set to the same standard as
J17 (see page 31 for more jumper information)
Integrator/
Panacea
RS-232
1
2 RxD
3 TxD
4
5 GND
6
7
8
9
Chapter 2: Installation
51
Advertisement
Table of Contents
