Table of Contents
Advertisement
3. Label the cables connected to the GPIM so that you can later reconnect each cable to the correct GPIM.
4. Disconnect the cables from the GPIM.
5. If necessary, arrange the cables to prevent them from dislodging or developing stress points.
NOTE:
If you are removing a double-high, double-wide GPIM such as the 24-Port Ethernet
XPIM, you must reinstall the center GPIM slot bracket.
6. Using a Phillips (+) screwdriver, loosen the captive screws on each side of the GPIM faceplate.
7. Grasp the handles on each side of the GPIM faceplate, and slide the GPIM out of the services gateway.
8. Place the GPIM in an electrostatic bag or on an antistatic mat.
9. If you are not reinstalling a GPIM into an empty slot, install a blank GPIM faceplate over the empty slot
to maintain proper airflow. If you are reinstalling another GPIM into the empty slot, see
Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway" on page
NOTE:
When installing a blank GPIM faceplate, make sure that the padded side of the
faceplate is facing up.
RELATED DOCUMENTATION
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the SRX Series Services
Gateway | 253
Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway | 253
Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module | 243
260
"Installing a
253.
Advertisement
Table of Contents
