Table of Contents
Advertisement
To install a Mini-Physical Interface Module (Mini-PIM) in the SRX Series Services Gateway:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the grounding point on the back of the services gateway.
2. Power off the services gateway by briefly pressing the Power button on the front panel. Wait for the
Power LED to turn off before proceeding.
3. Disconnect the services gateway from its power source:
For SRX210 or SRX220 Services Gateway, either unplug the power adapter from the AC power
outlet, or disconnect the power adapter from the power connector on the rear panel of the device.
For SRX240 Services Gateway, either unplug the AC power cord from the AC power outlet, or
disconnect the AC power cord from the AC power connector on the rear panel of the device.
4. Remove the Mini-PIM from the electrostatic bag.
5. Grasp the screws on each side of the Mini-PIM faceplate and align the notches in the connector at the
rear of the Mini-PIM with the notches in the Mini-PIM slot in the device.
CAUTION:
components on the Mini-PIM.
6. Slide the Mini-PIM in until it lodges firmly in the services gateway. See
Figure 42: Installing a Mini-PIM in an SRX Series Services Gateway
7. Using a 1/8-in. (3-mm) flat-blade (–) screwdriver, tighten the screws on each side of the Mini-PIM
faceplate.
8. Insert the appropriate cables into the cable connectors on the Mini-PIM.
Slide the Mini-PIM straight into the slot to avoid damaging the
Figure 42 on page
248.
248
Advertisement
Table of Contents
