Removing A Gigabit-Backplane Physical Interface Module From The Srx Series Services Gateway - Juniper SRX Series Manual

CAUTION:
you install blank faceplates or other GPIMs. This is necessary for maintaining radio
frequency compliance.
RELATED DOCUMENTATION
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the SRX Series Services
Gateway | 253
Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway | 253

Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services Gateway | 258

Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module | 243
Removing a Gigabit-Backplane Physical Interface Module from the SRX
Series Services Gateway
CAUTION:
not support hot-swappable functionality for GPIMs. The SRX650 Services Gateway
supports hot-swappable functionality for GPIMs.
If you remove a double-high, double-wide GPIM, replace the bracket before
This step is applicable only for the SRX550 Services Gateway as it does
258