Resetting The Counter - DURKOPP ADLER 911-211-10 Operating Instructions Manual

Programming
Checking or changing the bobbin
To change or check the bobbin:
1. Press the Bobbin change button.
 The display shows a prompt asking whether you wish to reset the
bobbin counter.
2. Press the Yes button if you wish to change the bobbin.
 The bobbin counter will be reset.
OR
3. Press the No button if you merely wish to check the bobbin.
 The bobbin counter will not be reset.
4. Remove the transfer plate.
5. Press the Threading mode button on the machine head.
 The hook cover opens.
6. Change or check the bobbin.
7. Press the Threading mode button on the machine head.
 The hook cover closes.
8. Press the pedal forwards.
 The machine moves into the insertion position.
9. Insert the transfer plate.
10. Press the pedal or press the Continue sewing button.
 The machine moves to the sewing position.
11. Press the pedal or press the Continue sewing button.
 The sewing procedure is resumed.

5.9 Resetting the counter

Depending on the set machine parameters, the counter counts the sewn
programs or sequences up or down. You can use the Reset counter
button to reset the counter to the start value ( p. 52).
To reset the counter:
1. Press the button Reset counter on the start screen.
 The counter is reset to the value defined in the machine parameters.
52 Operating Instructions 911-211-10 - 00.0 - 10/2020