Table of Contents
Advertisement
Setup
7.8 Performing a test run
When setup is complete, perform a test run to check the functionality of
the machine.
To perform a sewing test:
1. Switch on bobbin change mode.
2. Thread the needle thread ( p. 20).
3. Insert the bobbin ( p. 26).
4. Switch off bobbin change mode.
The control is started up.
5. Press the pedal backwards.
The reference run starts.
Information
The reference run is necessary in order to obtain a defined starting
position of the transport carriage.
6. Press the pedal forwards.
The machine moves to the loading position for the material to be
7. Load / insert the material or clamp.
8. Press the pedal forwards.
9. The sewing procedure is started.
Operating Instructions 911-211-10 - 00.0 - 10/2020
The transport carriage moves to the reference position.
sewn.
105
Advertisement
Table of Contents
