Safety - Vision Engraving & Routing Systems 1212 Operating Manual

Safety Precautions Safety Precautions Safety Precautions
Safety Precautions Safety Precautions
f f f f f or Vision Engra or Vision Engra or Vision Engra or Vision Engra ving T
or Vision Engra
!Keep hands clear of the spindle belt during operation.
!Keep hands clear of the bottom of the spindle during operation.
!Always stop the machine before making any adjustments.
!Keep clear of adjustment knobs located on the rear, left and right side of the table.
!Disconnect the table cable and spindle drive cable before servicing.
!Do not operate the system with covers removed.
!Wear safety glasses when cutting any materials that emit chips. Use of the optional vacuum
system will remove most chips
!Use extreme caution when inserting or removing cutters, as cutter surfaces are very sharp.
ving T ving T ables ving T ables ables ables
ving T ables

Safety

Page 3