Standard Indicator Keys - Cardinal 825 Installation And Technical Manual

Standard Indicator Keys

This section describes the Standard Indicator keys (displayed on the Weight screen) along
with their functions as programmed by the 825
Refer to the actual indicator screen while reading this section.
NOTE: In order to use the Standard Indicator keys, the operator must press the
alphanumeric letter key corresponding to the underlined letter on the key (e.g., Z for the
Zero key) or the first letter on the key (e.g., O for Operator) to perform the key function.
Note that the Navigation Keys can be used to select (highlight) the key and then after
pressing the ENTER key, the key function will be performed.
Operator
Pressing the O key will prompt for the input of a new operator.
1. The display will change to show the Login screen.
2. Enter the login and then press the  Down Arrow to advance to the password prompt.
3. Enter the password and then press the ENTER key to proceed.
4. Otherwise, press the ESC key to return to the Weight screen.
Scale
Pressing the S key (with multiple scales) will toggle through the available scales and, if
enabled, the totalizer. Note that pressing this key with only one scale, the screen will
display the message Only one scale.
Date/Time
Pressing the D key allows the operator to change the date and time. For information on
changing the date and time, refer to the Setting Date and Time section of this manual.
TARE
(Key Entry Tare)
This key allows the operator to enter a tare weight (up to the capacity of the scale). Note
that the tare weight is the amount of weight to be subtracted from the gross weight to obtain
the net weight.
1. Press the T key.
2. The display will change to show the Set Tare screen.
3. Using the numeric keys (use the period for the decimal point), enter the tare weight and
then press the ENTER key.
4. The display will return to the Weight screen, showing the Gross, Tare and Net weights.
NOTE: The tare weight will remain until another tare weight is entered or it is cleared.
Clearing the tare weight can be only performed when zero weight is on the scale.
1. With the zero weight on the scale, press the A (TARE (Pushbutton Tare) key.
2. The display will return to the Weight screen, showing gross weight only.
30
KEYPAD FUNCTIONS, CONT.
8545-M838-O1 Rev D  825 Installation & Technical
Standard indicator
menu selection.