Table of Contents
Advertisement
4.3.1 Drilling
Insert and tighten the drill bit.
Clamp the workpiece.
Release emergency stop.
Close drill chuck protection.
Push Start.
Press Stop.
4.4
Removing the drill chuck from the MT2 spindle holding fixture
The drill chuck and the taper mandrel are loosened from the drill spindle by means of a drill
drift.
WARNING!
Only disassemble the drill chuck if the drilling machine is disconnected from the
electrical supply.
Switch off the drilling
machine on the master
switch or disconnect the
mains plug.
Move the drill sleeve
down.
Turn the drilling spindle
until the openings of the
sleeve and of the drilling
spindle are superimposed.
Loosen the taper mandrel
of the drill chuck with the
help of a drill drift.
4.5
Adjustment of the mechanical drilling depth
To adjust the mechanical drilling depth.
Pull out the drilling depth stop.
Turn the drill depth stop.
Push the drill depth stop back in.
Img.4-3:
Mechanical drill depth stop
Operation
Version 1.0 - 2020-09-04
Drill drift
Drill sleeve
Drill chuck
or drill bit
Img.4-2:
Mechanical dog
Translation of original instructions
Removal
DX17E
EN
23
Advertisement
Table of Contents
