Printer To Usb - Toshiba B-EX6T Series Key Operation Specification

* When CFG files is selected, the message included in the CFG file is shown prior to the confirmation
display.
5. After confirming the data copy, the printer reads data from USB memory.
6. It takes about 3 to 5 minutes to read all data.
7. Copied Data
When saving other model's data is attempted, only the parameter settings are read. In this case,
parameters not supported by the destination printer are inapplicable. It takes about 3 seconds to copy
data.
* B-EX6T1/T, B-EX6T1-G, B-EX6T3-Tand B-EX6T3-G are regarded as the same model.
* B-EX4T1-T and B-EX4T1-G are regarded as the same model.
8. Copied Data of Parameters
Parameters not supported by the destination printer are read, but not applied. Also, even if the
destination printer has the same parameters with the source printer, options may be different.
9. When an error occurs during an access to the USB memory, the error message described in Section
9.12 USB MEMORY is displayed. The printer does not retry the operation.

9.12.2 PRINTER TO USB

・ ALL
Notes:
1. The firmware (BOOT/MAIN/CG/KANJI/HTML), storage area data, and parameter settings are copied to
the USB memory.
2. When an item to be saved is selected, the confirmation display is shown and the data is stored in the
USB memory. It takes about 40 seconds to copy all data.
3. A file is automatically created in the USB memory and named in the following format based on the
printer model and the date of creation.
/ATA0/SYSTEM/B-EX6T1-T1105.DAT (e.g. B-EX6T Type1 305dpi model, Nov. 5)
If a file with the same name already exists in the USB memory, it will be overwritten.
4. When the error occurs during an access to the USB memory, the error message described in Section
9.12 USB MEMORY is displayed. The printer does not retry the operation.
141