Pre Peel Off; Back Feed Speed; Auto Head Check; Ribbon Near End - Toshiba B-EX6T Series Key Operation Specification

・ OFF
The head-up function is disabled during cut issue or the rewinder is not used.
・ ON
The head-up function is enabled during cut issue or the rewinder is used.
Notes:
1. Whether or not to activate the head up action in the cut issue or to use the Rewinder in the batch or strip
issue is selected.
2. When this parameter is set to ON, the head-up function is enabled in the cut issue mode and the built-in
rewinder is usable in the batch issue mode, respectively. However, since there is no built-in rewinder
option in B-EX6T, it is effective only when a cut is issued.
3. Head-up cut is effective only when equipped with a ribbon save mechanism. For example, since the
B-EX6T3 does not have a ribbon save mechanism, even if it is set with the head-up, the head-up is not
performed.

9.5.7 PRE PEEL OFF

・ OFF
Disables pre peel off.
・ ON
Enables pre peel off.
Notes:
1. Pre peel off is automatically enabled when the print speed is set to 10 ips or faster for the strip issue.
(For the print speed of less than 10 ips, the pre peel off is enabled only when this parameter is set to
ON.) However, the print speed may be corrected depending on the EX I/O parameter setting as follows.
▪ EXI/O: TYPE 1 (Standard)
203-dpi model: 10 ips
305-dpi model: 8 ips
▪ EX I/O: TYPE 2 (Inline)
Specified speed
2. The pre peel off speed is the min. forward feed speed (3 ips).

9.5.8 BACK FEED SPEED

・ STD
3 ips
・ LOW
2 ips

9.5.9 AUTO HEAD CHECK

・ OFF
Disables the auto print head check.
・ ON
Enables the auto print head check.

9.5.10 RIBBON NEAR END

・ OFF
Ribbon near end is not detected.
・ 30m
Ribbon near end is detected when the remaining ribbon is 30-m long (Equivalent to ribbon
diameter of 38 mm)
・ 70m
Ribbon near end is detected when the remaining ribbon is 70-m long (Equivalent to ribbon
diameter of 43 mm)
Note: Since a detected remaining ribbon length has some margin of error, use the specified length as a
guide.
81