Table of Contents
Advertisement
2. PRINTER SETUP
2. PRINTER SETUP
2.1 Precautions
CAUTION!
Avoid using the printer in the
locations where it is
subjected to intense light
(e.g. direct sunlight, desk
light). Such light may affect
the sensors of the printer,
causing malfunctions.
ENGLISH VERSION EO1-33099
This section outlines the steps necessary to setup your printer prior to its
operation. The section includes precautions, connecting cables,
assembling accessories, loading media, and performing a test print.
To insure the best operating environment, and to assure the safety of the
operator and the equipment, please observe the following precautions.
Operate the printer on a stable, level, operating surface in a location
free from excessive humidity, high temperature, dust, vibration or
direct sunlight.
Keep your work environment static free. Static discharges can cause
damage to delicate internal components.
Make sure that the printer is connected to a clean source of AC Power
and that no other high voltage devices that may cause line noise
interference are connected to the same mains.
Ensure that the printer is connected only to AC mains that has a
proper ground (earth) connection.
Do not operate the printer with the cover open. Be careful not to
allow fingers or articles of clothing to get caught into any of the
moving parts of the printer.
Make sure to turn off the printer power and to remove the power cord
from the printer whenever working on the inside of the printer or
when cleaning the printer.
For best results, and longer printer life, use only TOSHIBA TEC
CORPORATION recommended media. (Refer to the Supply Manual.)
Store the media in accordance with the specifications.
This printer mechanism contains high voltage components; therefore
you should never remove any of the covers of the machine as you may
receive an electrical shock. Additionally, the printer contains many
delicate components that may be damaged if accessed by unauthorised
personnel.
Clean the outside of the printer with a clean dry cloth or a clean cloth
slightly dampened with a mild detergent solution.
Use caution when cleaning the thermal print head as it may become
very hot while printing. Wait until it has had time to cool before
cleaning.
Use only the TOSHIBA TEC CORPORATION recommended print
head cleaner to clean the print head.
Do not turn off the printer power or remove the power plug while the
printer is printing or while the Indicator Lamp is flashing.
The socket-outlet needs to be installed near the equipment and must
be easily accessible.
Pull out the plug from the outlet more than once a year to clean around
the prongs. Accumulating dust and dirt could cause a fire due to the
heat released by electric leakage.
E2-
1
2.1 Precautions
Advertisement
Table of Contents
