Table of Contents
Advertisement
Synchronizing with Other Modules below for more information about quantizing and clocks.
8.
Touch
to end recording if the Length parameter is set to Custom. There may be a delay between
Stop
when you touch
Stop
the Cell Type changes to CPLY, and the CPLY Wave screen is shown with the new WAV file loaded. The clip
name will be
with a numeric suffix.
RC
After you record a CV WAV file, that WAV file is available for use in other CPLY cells and presets as well. The WAV
file is saved on the microSD card with a file name the same as the name on the screen with a .WAV file extension.
If you have the general module setting
sample when recording ends if the Length parameter was used for recording. See General Module Settings above to
adjust the
setting.
RecToPlay
Note:
If you record into a loaded cell, the original WAV file remains intact on the microSD card and a new WAV file
•
is created. You may eventually need to use the microSD card in your computer to
Load a CV WAV file using a CREC Cell
You can also use a CREC cell to load a WAV file into a CPLY cell:
1.
Press HOME until you get to the
2.
Touch a cell that is aligned with a CV Output jack to open it.
3.
Change the Cell Type to CREC by touching the Cell Type button next to the grid icon in the top row of the
parameters screen, then select
screen.
4.
Touch
from the top menu to display the WAV file selection screen. Use the Control Knobs to scroll
Load
through the list of WAV files until the highlight is over the desired file.
5.
Touch
in the top right corner to load the selected file. The cell is then changed to a CPLY cell, and
Load
the CPLY Wave screen is shown with the selected WAV file loaded.
Play Back a CV W AV File Using a CPLY Cell
The CPLY cell will play back a CV sequence that was recorded as a WAV file. You can put the microSD card into your
computer to add WAV files to the card, or follow the steps in Record a CV Sequence Using the CREC Cell Type
above to record a new CV sequence. The CPLY cell can only be used in cells mapped to CV Output jacks because
the output is played out via the corresponding CV Output jack below the screen. CPLY cells do not output MIDI
signals. CPLY cells may be paired with one or more OUT cells to play up to 8 channels from the WAV file.
To create a CPLY cell:
1.
Complete a recording or loading of a CREC cell as described on the previous two pages, or set the cell type
to CPLY for a cell mapped to a CV Output jack.
2.
Press the INFO button to cycle between the CPLY Wave screen and the CPLY Parameters Screens.
3.
Configure the following parameters of the cell to control playback:
P. 22
6/13/18 7:54 PM
and when the recording ends due to quantization. When the recording has stopped,
set to
RecToPlay
ON
screen.
Main
from the list of Cell Types. You will now see the Load and Record
CREC
Digital Heart – Analog Soul
Toolbox User Manual
, toolbox will automatically start to play the new
Copyright 1010music LLC 2017
Advertisement
Table of Contents
