Table of Contents
Advertisement
MIDI
The MIDI Channel that will be used
when sending the MIDI signal for this
cell.
MIDI
The MIDI Port on the Toolbox module
Port
where the MIDI signal for this cell will
be sent.
Note:
If a value of a Gate Sequencer parameter is changed during playback of the sequence,
•
the change will take effect at the start of the next loop through the sequence.
If the value of the MIDI parameter is set to Default, no MIDI signal will be sent for this
•
GATE cell.
Clear the Notes in the Gate Sequencer
Sometimes you may want to erase all of the gate events in the gate sequencer and start over. Here's how:
1.
From the Gate Sequencer screen, touch Edit in the top menu, and then touch Clear. This will erase all of the
gate events from the Gate Sequencer.
2.
If you only want to remove some of the gate events, touch the events you want to remove and they will be
erased.
Copy and Paste Gate Events Between Gate Cells
The Edit menu in a GATE cell allows you to copy gate events between GATE cells.
1.
Open the Gate Sequencer for the source Gate cell, and touch
2.
Touch
or
Copy
Cut
currently selected GATE cell.
3.
Open the Gate Sequencer for the target GATE cell, and touch
4.
Touch
in the drop down menu. All of the gate events from the source GATE cell will now be added
Paste
to the target GATE cell. Any previously existing gate events in the target GATE cell will remain as well.
Import a MIDI File into a Gate Sequencer
Another way to get notes into a Gate sequencer is to import a MIDI file from the microSD card. Follow these steps:
1.
Copy a standard MIDI file onto the microSD card and then reinsert the card into toolbox. The MIDI file
should have a .MID file extension.
2.
From the Gate Sequencer screen of a GATE cell, touch
drop down menu.
3.
Use the Control Knobs to highlight the file you want, and then touch
sequencer grid will now display the notes imported from the MIDI file. Any previous notes in the piano roll
will be erased. Given the nature of the Gate Sequencer, only On/Off note information is imported. The pitch
is not used.
Configure a Note Sequencer (NO TE)
Toolbox's Note Sequencers are piano roll style sequencers that generate both CV and MIDI outputs. The CV output
may be in the form of a pair of gate and pitch signals for each Note Sequencer, just a gate signal, or just a CV pitch
signal depending on which column or columns the cell placed in. The CV Output is monophonic. It will play back the
most recently entered note for each step in the sequence.
When a NOTE cell spans a Gate and a CV Output, the Gate Output will indicate when the note is on or off, and the
CV Output will represent the pitch of the note. The Gate output will be +5V for an ON signal and 0V for an OFF
signal. The pitch signals on the CV Outputs will carry 1 volt per octave and support a range of 0 to 5 volts. Middle C
is at 2 volts.
6/13/18 7:54 PM
in the drop down menu. If you use Cut, the gate events will be removed from the
Digital Heart – Analog Soul
Default, Ch 1
No
through Ch 16
1 through 4
No
from the top menu.
Edit
from the top menu.
Edit
in the top menu, then touch
Edit
in the top right corner. The
Load
Toolbox User Manual
Figure 1 3: Ga te
Sequencer P a ra meters
Screen 2
in the
Import
P. 15
Copyright 1010music LLC 2017
Advertisement
Table of Contents
