Table of Contents
Advertisement
Playback Presets
Before we start creating our own sequences, lets make sure the module is setup properly by playing back some
content from a preset that comes with the module.
Select a Preset
A preset is a set of pre-configured sequences, function generators and modulators. You can use the 1010music
presets or create your own. To select a preset:
1.
Press the HOME button to display the Main screen if needed.
2.
Cycle through the presets by touching the
Screen on either side of the name of the preset (e.g. MANUAL in Figure 2: Main
Screen Overview above).
3.
Alternatively, you can touch the name of the preset or the space above it to display
the Preset Selection screen.
4.
Turn a Control Knob to select the desired preset.
5.
Touch
to load the selected preset and go back to the Main screen.
Load
Save a Preset
Toolbox does not automatically save your changes to presets. You have to manually save by
following these steps:
1.
From the Main screen, touch the preset name to display the Preset Selection
screen.
2.
Touch
to display the Preset Edit Submenu.
Edit
3.
Touch
to save the changes to the preset and return to the Main screen, or
Save
touch
to save the changes to a different preset.
Save As
Toolbox allows you to switch presets in real time to switch all patterns at once. If you switch
presets during playback, the change will take effect at the beginning of the next bar. This
change is quantized to measure to give you smooth transitions. You can also use modulation
to alter pattern length, step size, and transposition to get maximum use out of a single
pattern.
Learn more about managing presets in Preset Management below.
Start Playback of the Sequencers and Function Generators
Toolbox comes with two presets that demonstrate the use of the sequencers and function generators. Let's play one
of them to demonstrate the use of the module. Select one of the two supplied presets: STABS or BBQ. Note that
these presets have Gate sequencers configured for Gate outputs 2 and 3.
To control playback of all of the sequencers and function generators:
1.
Press the HOME button to display the Main screen if needed.
2.
Touch
in the lower left corner of the screen to toggle playback on and off. The
Play
when it is selected. The blue bar at the bottom of the
3.
You can also use the bottom CV Mod In jack to control playback. Each high signal received on the
bottom CV Mod In jack will toggle playback on and off.
Note:
When the module is mounted with the screen on top, CV Mod In 4 controls playback. When the module is
•
configured to run with the Flipped UI and the screen on the bottom, CV Mod In 1 controls playback.
Toolbox will now generate a sequence of gate signals out through the Gate Output jacks 1, 2, 3 and 4, if the
corresponding cell is configured. These gate signals can trigger notes on another module. Listen to the output of
the receiving module to hear the sequences. Other outputs may be sent to other jacks if the corresponding cells are
configured, and are not muted.
P. 10
6/13/18 7:54 PM
and
buttons at the top of the Touch
+
–
button indicates when playback is active.
Play
Digital Heart – Analog Soul
Toolbox User Manual
Figure 8: Preset
Selection Screen
Figure 9: Preset E dit
Submenu
button is pink
Play
Copyright 1010music LLC 2017
Advertisement
Table of Contents
