Table of Contents
Advertisement
Parameter
Description
Amount
Adjusts the level of the
voltage output signal.
Launch
This controls how a note
Mode
trigger affects the playback
of a cell.
Play
Controls the playback
Rate
speed of the CV signal.
100% plays the file back at
the original recorded
speed. Values between 99
and 0 will reduce the
playback speed to the
corresponding percentage.
Values from -1 to -100 will
cause playback to reverse.
Clk
Determines the input that
Source
will be used to trigger or
gate playback of the cell.
Start
Point where playback will
begin when playing
forward or ends when
playing in reverse.
Expressed in samples.
LpStr
Point where the looping
will begin when playing
forwards, or looping will
end when playing in
reverse. Expressed in
samples. Must be before or
equal to LpEnd.
6/13/18 7:54 PM
Range of Values
When a
-100% to 100%
negative value is selected, the
control voltage is inverted.
: The cell plays
AlwaysOn
back continuously.
: Playback starts
Trigger
when the selected Clk Source
signal has a high Gate value.
Playback will continue through
the end.
Begin the cell
Gate:
playback in the same manner
as
mode. But in
Trigger
mode, playback will
Gate
stop when the Gate signal
goes low.
-100 to 100%
The internal module
INT:
clock
The CV signal
EXT1 – 3:
in the corresponding CV Mod
In jack.
The internal
Gate1-4:
module signal that is being
sent to Gate output 1-4.
number of samples in
0 to
the file
number of samples in
0 to
the file
Digital Heart – Analog Soul
Toolbox User Manual
Mod
Target?
Yes
No
Figure 2 2 : CP ly
P arameters Sc reen 1
Yes
No
Yes
Yes
Figure 2 1 : CP ly
P arameters Sc reen 2
Copyright 1010music LLC 2017
P. 23
Advertisement
Table of Contents
