Table of Contents
Advertisement
To perform the scale removal program, you will need a container with minimum capacity of 0.6
litres and a KRUPS F 054 (40 g) descaling sachet.
GB
Press the
key MAINTENANCE => OK => DESCA-
LING to start the automatic cleaning program when
the "Scale removal needed" message is displayed.
The scale removal program is in three parts – the scale removal cycle itself, then 2 rinsing cycles.
Only use KRUPS scale removal products. You can obtain scale removal products from ROWENTA
Service Centres.
The manufacturer may not be held responsible for damage to the appliance through use of other
products.
If a power cut occurs during the cycle or if you unplug your machine, the cycle will re-start at the
step in progress when the incident occurred, without the option of postponing this operation.
Be sure to complete the entire scale removal cycle to avoid any risk of intoxication. The scale
removal cycle is a continuous cycle and the pump can be heard intermittently. Do not put your
hands under the coffee outlets during the cycle.
Make certain to protect your work surface during scale removal cycles, especially if they are
made of marble, stone or wood.
GENERAL MAINTENANCE
Always remove the power supply cord from the socket and let your appliance cool down before
cleaning it.
Do not use utensils or cleaning products likely to scratch or corrode the appliance.
Wipe the body of the appliance on the outside using a moist cloth.
Clean the cleaning tray, the drip tray and its
grid, the coffee grounds collector and its
front part using warm water and washing
up liquid detergent.
These parts are not designed to go into the dishwasher.
Just follow the instructions shown on the screen,
making sure the sachet dissolves fully.
To make the cleaning of the coffee
grounds collector easier, dismantle it as
shown above.
12
Rinse the water
tank with tap water
Advertisement
Table of Contents
