Preparing Steam; Frothing Milk - Rowenta Automatic ES6930 Manual

Table of Contents

Advertisement

PREPARING STEAM

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up
liquids. As you need a higher temperature to produce steam than to make an espresso, the
appliance runs an additional pre-heating phase for steam.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.

FROTHING MILK

We recommend that you use very cold, fresh pasteurised or UHT milk that has been recently
opened. Do not use untreated milk. After the steam function has been used, the nozzle will be hot,
and we recommend that you wait for a few moments before handling it.
Check that the steam
Pour the milk into
nozzle is correctly
your milk jug. Only
fitted.
half fill it.
Immerse the nozzle
in the milk.
To remove any
Let the steam
remaining milk from
escape for at least
the steam nozzle,
10 seconds and then
place a container
again press the "hot
under the nozzle and
water" key
press the "hot water"
stop the process.
key
.
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.
While the screen displays the drink selection menu, press the "steam" key
. A screen will inform you that the appliance is being pre-heated. Once
the pre-heating phase has been completed, a message will ask you to place
a container under the steam nozzle. Press the "steam" key
generating steam. A little water will be produced first and then steam will
start. Use the same key to stop steam generation.
Press the "steam"
key
the instructions on
the screen.
You can remove the steam nozzle for thorough cleaning. Wash it
using a brush with water and a little non-abrasive washing up
liquid. Rinse and dry it. Before re-fitting, make certain that the air
inlet holes are not clogged by milk residues. Clean out the holes
to
with a needle if necessary.
Once your milk is
frothy enough...,
and follow
9
GB
again to start
Again press the
"steam"
key to
stop the cycle. Be
careful, because
the cycle does not
stop immediately.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Automatic es6930pnAutomatic es6930pe

Table of Contents