Preparing Steam; Frothing Milk - Rowenta AUTOMATIC Manual

2-CUP FUNCTION
You can use your appliance to make 2 cups of coffee or espresso. Remember not to remove the cups
after the first cycle. You have now prepared your appliance. The
Put two cups under the
coffee outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
If you first press the
account.

PREPARING STEAM

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up
liquids. As you need a higher temperature to produce steam than to make an espresso, the appliance
runs an additional pre-heating phase for steam.
Press the
The
Once pre-heating has been completed, the
can start producing steam by again pressing the
Press the
Be careful, because the cycle does not stop immediately.

FROTHING MILK

We advise you to use very fresh, very cold milk.
The milk and jug must be cold, ideally between 6 and 10 °C.
We therefore advise you against putting the jug under hot water before using it.
Pour the milk into
Check that the steam
your milk jug.
nozzle is correctly
fitted. Immerse the nozzle
in the milk.
x 2
Select the key or
twice rapidly in succession. The
double flash to confirm that you have ordered 2 cups of coffee.
key and then the (or vice versa), the second action will not be taken into
key.
light will flash while the appliance heats up.
button again to stop the cycle.
Activate the steam
function as explained
above.
8
light will stay on.
The appliance will
automatically sequence
2 complete
coffee-making cycles.
key according to your choice, pressing
light will come on with a
light will remain on continuously and you
key.
Once your milk is
frothy enough...
GB
...again press the
key to stop the cycle.