Teldat Regesta-PLC Manual page 22

2 Web Interface
System – SNMP.
Fig. 40:
This is divided into the following sections:
(a) Hosts:
Allows you to configure all hosts to which SNMPv1 traps generated by the device must be sent.
• Adding and configuring a host
To add a new host, carry out the following steps:
(a) Select the New Host option from the pull-down menu.
(b) Specify the following configuration parameters.
IP Address: IP address of the host where the SNMPv1 traps generated by the device are sent to.
UDP Port: UDP port where the host expects the traps to arrive. Default is 162.
Send Standard Traps: Enables/disables generic trap sending.
Send Enterprise Traps: Enables/disables the sending of specific company traps containing Teldat events.
(c) Click on Apply.
To cancel the modifications, click on Cancel.
18
Teldat S.A.
Regesta-PLC