2N NetSpeaker Manual page 81

Authorisation
The AppName item is used for application identification. The application cannot
continue communicating until it receives the <bind Status="OK"/> reply from the 2N
NetSpeaker Server. The server thus confirms the connection and creation of a
communication channel.
Explicit authorisation - LOGON method
Or, you can enter your login and password simply as follows:
1. Check whether the library offers the LOGON method after receiving the request
for authorisation and, if yes, then:
2. Send
Password="..."/>; where ... is to be replaced with the user name and password
(default name: Admin, password: 2n).
3. Wait for the reply: <auth Method="LOGON" Status="OK"/>.
If the reply contains the Status attribute with OK value, it means that the XML bridge
has been successfully authorised with the data received. Any different value of the
Status attribute means that access has been denied.
Besides the <auth Method="..." Status="OK"/> reply, successful authorisation is
manifested by the following reply from the XML bridge to bind: <bind Status="OK"/>.
This signals that the communication channel has been successfully configured and
authorised and is ready for sending messages in both directions now.
The following answers have been added for different situations:
NNB_XML_STATUS_OK ... external application can start sending other
commands.
NNB_XML_STATUS_ALREADY_BOUND ... application ignores this error and can
send commands, bind no longer needed.
NNB_XML_STATUS_NEIGHBOUR_IS_UNREADY ... application must repeat the
bind command after a time delay of 100 ms at least.
No new commands can be sent until the CTI interface responds to the bind
command.
If the application does not receive an answer in about 1 sec, it repeats the bind
®
2N TELEKOMUNIKACE a.s., www.2n.cz
the instruction
Request
<bind ConnType="LOCAL" AppName="SpkCtiTest"/>
Response
<auth>
<method Name="LOGON"/>
</auth>
Request
<auth Method="LOGON" LoginName="login" Password="password"/>
Response
<auth Method="LOGON" Status="OK"/>
Response
<bind Status="OK"/>
<auth Method="LOGON"
®
LoginName="..."
81