2N NetSpeaker Manual page 71

help
set
(parameter)(value)
get (parameter)
print
save
exit
reboot
List of Parameters
dhcp client: This parameter enables/disables automatic obtaining network
parameter settings from the DHCP server in the LAN.
ipaddr
netmask
defaultgw
pwd
activemode
®
2N TELEKOMUNIKACE a.s., www.2n.cz
This command displays the list of available commands
This command sets the parameter to a selected value.
Example: set dhcpclient 1
This command displays the current parameter value.
Example: get dhcpclient
This command writes out all parameters including values.
This command saves all parameters changes into the 2N®
NetSpeaker memory.
This command quits connection with the Telnet server.
This command resets the equipment.
Setting options:
Automatic network parameter obtaining is disabled. Use manual
0
settings: ipaddr, netmask and defaultgw.
1 Automatic network parameter obtaining is enabled.
Default setting: 0
®
2N NetSpeaker static IP address. Use this setting if dhcpclient is set to
0.
Default setting: 192.168.1.100
Network mask for static IP address setting. Use this setting if dhcpclient is
set to 0.
Default setting: 255.255.255.0
Default gateway for packets routed outside the LAN. Use this setting if
dhcpclient is set to 0.
Default setting: 192.168.1.1
®
2N NetSpeaker 's own password for authorising connection initiated by
®
the 2N NetSpeaker
®
2N NetSpeaker Server
NetSpeaker units in the system. This password is used for Telnet server
connection authorisation too.
Default setting: admin
®
2N NetSpeaker is connecting actively to the
Remember to set the srvipadr and srvport parameters correctly if 1 is
selected.
Setting options
Server . The same password must be stored in the
global settings and must be identical for all
®
2N NetSpeaker Server
®
2N
.
71