Loudspeaker(s)
2 x 4Ω STEREO
2 x 8Ω STEREO
2 x 16Ω STEREO
4Ω MONO
8Ω MONO
Use the
channel and R + and R – for the right channel. Use the left channel terminals for the
MONO mode.
Headphone/External Amplifier Connection
®
2N
NetSpeaker
3.5mm jack is available on the front panel.
Digital Output Use
®
2N
NetSpeaker
amplifier/alarm/activation. The output is available on terminals marked LOGIC OUT and
allows for switching of up to 24V/1A AC/DC loads.
Program the output either to the N/O (normally open) or N/C (normally closed) mode.
Warning
Do not exceed the upper voltage and current limits to avoid irreversible damage
of the equipment.
Note
The current
to www.2n.cz for
TELEKOMUNIKACE Technical Support staff please for more information.
Digital Input Use
2N
of movement or other applications. This input is available on the LOGIC IN
terminal. Up to 5 to 24V DC voltage can be applied to the input against the
ground terminal marked DC IN –.
Warning
Do not exceed the maximum voltage values (24V) applied to the LOGIC IN input
to avoid irreversible damage of the equipment.
Note
The current
to www.2n.cz for
TELEKOMUNIKACE Technical Support staff please for more information.
Memory Card Use
2N
in case the equipment is not connected to the LAN permanently or temporarily.
The MicroSD card slot is available on the
Note
®
2N
TELEKOMUNIKACE a.s., www.2n.cz
®
2N
NetSpeaker
back panel terminals marked L + and L – for the left
is equipped with a headphone/external amplifier connector. The
is equipped with a relay switch for light signalling/external
®
2N
NetSpeaker
2N
®
NetSpeaker
is equipped with a digital input for an optional button, sensor
®
2N
NetSpeaker
2N
®
NetSpeaker
is equipped with a MicroSD card slot for storing music or voice
12V/2A
2 x 2.5W
2 x 7W
2 x 4W
1 x 14W
1 x 8W
FW version does not support this function. Refer
®
NetSpeaker
FW updates. Contact the 2N
FW version does not support this function. Refer
®
NetSpeaker
FW updates. Contact the 2N
®
2N
NetSpeaker
PoE
2 x 2.5W
2 x 4W
2 x 4W
1 x 8W
1 x 8W
front panel.
68