? The current
to www.2n.cz for
TELEKOMUNIKACE Technical Support staff please for more information.
LAN Connection
2N
LAN interface via the RJ–45 connector on the back panel. Always use CAT–5d or
higher class cables for reliability reasons.
The LAN interface is equipped with the Auto MDIX function for automatic
detection of a straight or cross–over cable.
The LAN interface can also be used for the
through active network elements or injectors meeting the IEEE 802.3af standard.
Note
? With PoE, the integrated amplifier power output is limited to 8W. To utilise the
maximum power output of the amplifier, feed 2N® NetSpeaker from an external
12V DC/2A power supply.
Power Supply Connection
2N
the LAN interface. In case this option is unavailable, use a 12V DC/2A (Part No.
914102E) power supply, or another power supply on condition that you keep the
nominal values included in the
Electric Parameters subsection.
Connect the 12V DC power supply either to the back panel supply connector
marked DC IN, or terminals marked DC IN + and DC IN –.
Warning
? If you use an adapter other than the recommended one, do not exceed the
nominal supply voltage value of 12V. Also make sure that the supply voltage
polarity is correct. Exceeding nominal values and/or incorrect connection may
lead to irreversible damage of the equipment.
®
2N
This section describes the
Here is what you can find in this section:
Default Setting
Basic Parameter Settings
Firmware Upgrade
®
2N
Default Setting
In some cases, it may be useful to reset the
RESET button on the back panel. Do this, for example, if
respond, which may be caused by incorrect LAN settings, LAN configuration changes,
forgotten password and so on.
®
2N
TELEKOMUNIKACE a.s., www.2n.cz
®
2N
NetSpeaker
®
NetSpeaker
can be connected to a standard local area network using a
®
NetSpeaker
can be fed using active network elements or PoE injectors via
NetSpeaker
Configuration
2N
NetSpeaker
Configuration
FW version does not support this function. Refer
®
2N
NetSpeaker
FW updates. Contact the 2N
®
NetSpeaker
configuration.
®
2N
NetSpeaker
®
2N
NetSpeaker
power supply
factory values using the
®
2N
NetSpeaker
ceases to
69