Table of Contents
Advertisement
Chapter 2
Using the iSCSI Hard Disk Connection Tool
iSCSI Hard Disk Connection Tool
When you set up the TeraStation with TeraNavigator, the iSCSI Hard Disk Connection Tool was installed. You will use this
tool to connect to the TeraStation.
To launch:
Click [Start] - [All Programs] - [BUFFALO] - [iSCSI Hard Disk Connection Tool] - [iSCSI Hard Disk Connection Tool].
Name
Target product
Model name
Series Name
IP Address
Subnet Mask
MAC Address
Firmware
iSCSI Service
Volume
Note:
If your computer is connected to many volumes on a TeraStation, it may take some time for the utility to detect all
the volumes. For example, it takes about 20 minutes for a computer to detect 32 connected volumes from a single
TeraStation. This time may vary depending on your computer and network. Volumes are detected successively, so
please wait until all volumes are detected before making changes in the utility.
TeraStation III iSCSI User Manual
Descriptions
Select a TeraStation from the drop-down list. Any iSCSI TeraStations on the LAN should be available.
[Register the iSCSI Hard Disk] registers all volumes of the selected TeraStation to your computer.
If a TeraStation is already registered, click [Remove the registered iSCSI Hard Disk] to unregister all
volumes of that TeraStation.
TeraStation's model name
TeraStation's series name
TeraStation's IP address.
TeraStation's subnet mask.
TeraStation's MAC address.
TeraStation's firmware version.
Shows whether the iSCSI service of the TeraStation is running or stopped.
Select individual volumes from a registered TeraStation.
Select a volume and click [Connect]. The selected volume will be recognized as a local drive on your
computer in My Computer.
Volumes will not be visible until the TeraStation is registered above.
If IP address restrictions are set, volumes are displayed only on computers with allowed IP addresses.
If a volume is connected, click [Remove] to disconnect it.
7
Advertisement
Table of Contents
