Table of Contents
Advertisement
Reconnect a TeraStation
To reconnect a TeraStation that you previously removed, follow the instructions below to register it and connect a
volume.
1
Connect the TeraStation and power it on.
2
Click [Start] - [All Programs] - [BUFFALO]-[iSCSI Hard Disk Connection Tool] - [iSCSI Hard Disk Connection Tool] to
open the iSCSI Hard Disk Connection Tool.
3
4
The volume you just connected will be added as a local drive to [Computer] or [My Computer].
Notes:
• If a volume is not formatted, it is not added as a local drive. To format, select [Launch Disk Management] from [Setup]
menu in the iSCSI Hard Disk Connection Tool.
• To connect multiple volumes at once, choose [Connect some Volumes] from [Setup] menu.
• To connect volume(s) constantly, check [Connect on Start Up].
• With Windows XP or Windows 2000, you cannot connect to volumes larger than 2 TB. Use Logical Volume Manager (LVM)
to create volumes smaller than 2 TB, then connect.
TeraStation III iSCSI User Manual
1 Select the TeraStation from [Target product].
2 Click [Register the iSCSI Hard Disk].
Note:
If you set access restrictions for [Access Control (Whole System)] from
[Basic] - [Security] in the Web Admin interface, enter the user name and
password to continue.
1 Select the volume to connect to.
2 Click [Connect].
Note:
If you set access restrictions for [Access Control] from [iSCSI Volumes] -
[Create Volume], enter the user name and password to continue.
11
Advertisement
Table of Contents
