Buffalo TeraStation III TS-IXL User Manual page 49

Network
IP Address Settings
Click [Modify Settings] to
change settings.
*The LAN cable connected to
LAN port 2 should be set for
Ethernet 2.
Ethernet Frame Size
Click [Modify Settings] to
change settings.
*The LAN cable connected to
LAN port 2 should be set for
Ethernet 2.
Port Trunking
Click [Modify Settings] to
change settings.
TeraStation III iSCSI User Manual
DHCP
Primary IP Address
Subnet Mask
Default Gateway Address Specify the IP address if the default gateway if it exists.
Primary DNS Server
Secondary DNS Server
Ethernet Frame Size
Port Trunking
If a DHCP server is available, enable DHCP to assign IP addresses
automatically.
If not using DHCP, enter an IP address manually.
Set a subnet mask.
Specifies an IP address for the primary DNS server.
Specifies an IP address for the secondary DNS server.
You can improve data transmission speed by increasing the maximum
amount of data that can be sent at once.
• [1518 bytes (Default)]
• [4102 bytes (Jumbo Frame)]
• [7422 bytes (Jumbo Frame)]
• [9694 bytes (Jumbo Frame)]
Set this option to connect 2 Ethernet ports to the TeraStation. The
following settings are available:
• [Off]: Port trunking is not used.
• [Round-robin policy]: Sets a round-robin policy for fault tolerance
and load balancing.
• [Active-backup policy]: Sets an active-backup policy for fault
tolerance.
• [XOR policy]: Sets an XOR (exclusive-or) policy for fault tolerance and
load balancing.
• [Broadcast policy]: Sets a broadcast policy for fault tolerance.
• [Dynamic link aggregation]: Sets an IEEE 802.3ad dynamic link
aggregation policy.
• [Adaptive transmit load balancing (TLB)]: Sets a Transmit Load
Balancing (TLB) policy for fault tolerance and load balancing.
48