Turning The Terastation On And Off - Buffalo TeraStation 3010 User Manual

Chapter 1 Getting Started
10
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
11
Fan
Spins to avoid overheating inside. Do not block the fan.
12
USB 3.0 Port (
Compatible Buffalo USB drives, USB memory devices, and USB UPS connections can be connected. USB hubs
are not compatible.
13
LAN Port 1 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
14
LAN Port 2 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
15
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
16
Anti-Theft Security Slot ( )
Use this slot to secure your TeraStation with a cable lock (not included).
17
Serial Number
This sticker shows the TeraStation's serial number.
18
UID Button
Press the UID button on the front or the back of the unit to cycle the blue LED on and off.
19
Link LED
Glows green when the TeraStation is connected to a network.

Turning the TeraStation On and Off

Note: Do not disconnect or reconnect the internal drives while turning on or off the TeraStation.
Press the power button on the TeraStation to turn it on.
To turn off the TeraStation, press and hold the power button for three seconds. Don't unplug the TeraStation without
turning it off first. You can also shut it down and restart it remotely from Settings.
1
Double-click the NAS Navigator2 icon (
)
) to start NAS Navigator2.
11