System Menu - RadioLink T8S User Manual

• Independently adjustable elevator travel allows for differences in up & down travel.
• The separate ELEVON settings for each condition can be set. (GLIDER only)
V-TAIL: This function is used on the V-tail aircraft.
V-TAIL mixing is used with v-tail aircraft so that both elevator and rudder functions are combined for the two tail
surfaces. Both elevator and rudder travel can be adjusted independently on each surface.
ADJUSTABILITY:
• CH2 and CH4 are required.
• Independently adjustable travel allows for differences in servo travels.
• Rudder differential is not available. To create rudder differential, set RUD1 and 2 as 0, then use two
programmable mixes in SYSTEM Menu, RUD-ELE and RUD-RUD, setting different percentages for up and
down. These are new rudder travels. Turn the trim and link off, switch assignment null so rudder won't be
accidentally turned off.
Note
V-TAIL function and ELEVON/AILEVATOR mix functions can't be activated at the same time.
Make sure to move the elevator and rudder sticks regularly while checking the servo motions. If a large travel
value is set, when the sticks are moved at the same time, the controls may mutually disturb or run out of travel.
Decrease the travel until no disturbance occurs.

3.3.4 SYSTEM Menu

There are three parameters to set: "AUX-CH" "PROG.MIX1" "PROG.MIX2"
AUX-CH
CH5/6/7/8 can be personalized to different switches. If any of the auxiliary channels is not for use, NULL should
be set.
TX Alarm
The default low voltage value is 3.0V, which can be personalized as well. When the transmitter voltage is lower
than the value set, T8S will make D sound to warn.
STK-MODE by default
Mode 1 is throttle at right while Mode 2 is throttle at left. Mode 3 is throttle at right for toys while Mode 4 is
11
Radiolink Electronic Ltd
www.radiolink.com