Placement Before Takeoff; Powering On/Off - YUNEEC Typhoon H Plus User Manual

Placement before Takeoff

WARNING: Always operate the TYPHOON H PLUS in open areas (approximately 10000 square feet/930
square meters or more) that are free from people, vehicles, trees and other obstructions. Never fly
near or above crowds, airports or buildings.
Never attempt to operate TYPHOON H PLUS nearby tall buildings/obstructions that do not offer a clear
view of the sky (a minimum clearance of 100°).
Be sure to place the TYPHOON H PLUS on a level and stable surface before powering ON the TY-
PHOON H PLUS Aircraft and the ST16S Ground Station.
IMPORTENT NOTE: STEP BACK APPROXIMATELY 26 FEET (8 METERS)
BEHIND THE TYPHOON H PLUS.
NOTICE: Pilots are recommended to take off the aircraft in Angle Mode. If the pilot takes off the aircraft
in Smart Mode, make sure to keep the air craft 32.8ft (10m) away from the pilot.
NOTICE: For the best performance, the 5.8GHZ patch antenna should be pointed to the aircraft.

Powering ON/OFF

NOTICE: Please make sure all firmware is the latest version. Firmware and the user manual may be
downloaded from web site: www.yuneec.com. The quick start guide does not replace the user manual.
Turn on the ST16S, and then press the power button on TYPHOON H Plus. Release the button when
the aircraft emits a rising tone. Power on the ST16S before powering on the UAS.
NOTICE: If the main LED blinks red slowly, the initialization has failed. The aircraft needs to be pow-
ered on again. To power off the aircraft, press and hold the power button until the aircraft emits a fall-
ing tune.
NOTICE: After hearing a rising tune, the main LED indicator will blink green for 1 to 2 seconds once
with flight battery fully charged, yellow with half charged and red with low voltage.
POWERING
ON ST16S
10
POWERING ON
TYPHOON H
PLUS