Terms And Conditions; Manufacturer's Liability; Storage And Pre-Installation; Storage Procedure - Emerson Bettis XTE3000 Installation, Operation And Maintenance Manual

Appendix
October 2019
D.4

Terms and Conditions

Emerson guarantees every product to be free from defects and to conform to industry
standards. Unless otherwise specified, the warranty period is one year from the date of
installation by the first user or eighteen months from the date of shipment to the first user,
whichever occurs first.
No warranty is given for products that are subject to improper storage, improper
installation, misuse, or are modified or repaired by unauthorized personnel.
Repair work resulting from improper use will be charged at standard rates.
D.5

Manufacturer's Liability

Emerson will not accept any liability in the event of:
•
•
•
•
D.6

Storage and Pre-Installation

D.6.1

Storage Procedure

NOTICE
Not following the procedures according to this document will invalidate the product warranty.
Normally the optional extension for additional entry or additional electronic card is directly
mounted on the base model of XTE3000 and leaves the factory in perfect condition. In
this case the general storage procedure as stated in section 2 must be followed. When
the above extension is shipped separately for a field upgrade on an existing XTE3000 unit,
this extension must be stored in a protected area while ensuring that the explosion-proof
joints are well-protected and kept free of damage. The standard plastic plugs used to
protect the conduit entries during transport are not explosion-proof nor waterproof; these
plugs are only intended to prevent entry of foreign objects. The extension for additional
entry/entries or additional electronic cards maintains the same weather-proof degree of
protection as the base XTE3000 model. Good operating condition can only be maintained
if the extension is correctly installed/connected on site and if it has been correctly stored.
D.6.2

Checks to be Performed Before Installation

Before installing extensions for additional entries or additional electronic cards on a base
XTE3000 unit, the following checks are recommended:
•
•
•
148
Use of product in a fashion that contravenes local safety at work legislation.
Incorrect installation relating to, disregard for, or incorrect application of the
instructions as provided on the product nameplate and in the Installation,
Operation, and Maintenance Manual MAN-02-04-97-0713 and Appendix D within.
Modification of the product without Emerson authorization.
Work done on the product by unqualified or unsuitable personnel.
Condition of joint surfaces between compartment covers and the main housing.
Condition of the threads on the conduit entries.
Whether the enclosure covers or the actuator body are cracked or broken.
Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1
Appendix